EXPERIMENT > Flux-Vortex Field Mapping and Deformation

ABscope: Planar Electromagnetic Field Reconstruction (X, Y + T)

Can a single launched electromagnetic event be mapped as an organized, translating field structure, and how does that structure respond to a controlled disturbance?

Purpose

This is a measurement companion to Single Flux-Vortex Emission. The proposed free flux-vortex ring is the candidate structure. The instrument must determine what field configuration actually leaves the source; a received pulse alone does not establish a ring.

Working Hypothesis

A suitably excited and matched source may launch an isolated electromagnetic structure. Once detached, its field organization may persist during free propagation. A deliberate change in the propagation environment may distort, reflect, scatter, or otherwise redistribute the structure. These alternatives are to be distinguished by measurement, not assumed in advance.

Conceptual Apparatus

Pulsed source Candidate structure X,Y scan plane E/H field probe Controlled disturbance ABscope: X,Y,t

Measurement principle: Trigger a reproducible emission event, sample the local electric and magnetic fields at known coordinates and delays, and reconstruct a time-resolved planar map. Repeat at additional planes if the initial result justifies full three-dimensional reconstruction.

Initial Scale and Timing

For a proposed structure approximately 1 cm long in the direction of travel, the nominal passage time at free-space propagation speed is:

\[\Delta t \approx \frac{0.01\ \mathrm{m}}{3\times10^8\ \mathrm{m/s}} \approx 33\ \mathrm{ps}\]

This is a transit-time target, not a complete instrument bandwidth specification. Smaller features require finer temporal and spatial resolution. Probe loading, trigger jitter, and the source waveform must be characterized before interpreting apparent field topology.

Proposed Instrumentation

Measurement Procedure

  1. Baseline: measure the source pulse, feed impedance, return signal, and received waveform with no disturbance present.
  2. Spatial scan: sample a grid of X,Y positions at repeated trigger delays to obtain a field map over time.
  3. Component scan: repeat with probe orientations sufficient to distinguish circulating from purely transverse or reflected fields.
  4. Translation test: repeat the mapping at two or more downstream planes. Look for a recognizable pattern moving with a reproducible delay.
  5. Distortion test: insert one controlled discontinuity; repeat the same scan and compare with the undisturbed map.
  6. Controls: move the disturbance, remove it, reverse probe orientation, and vary source amplitude and matching independently.

Measurement Ledger

QuantityWhat it tells us
\(V_s(t), I_s(t)\)Source-side excitation and input energy
\(Z_{\mathrm{in}}(\omega)\)Source loading, reactive exchange, and matching
\(E_x,E_y,E_z\)Electric-field geometry and temporal change
\(H_x,H_y,H_z\)Magnetic-field geometry and circulation
\((x,y,t)\) and scan planePosition, arrival delay, and apparent translation
\(\mathbf{E}\times\mathbf{H}\)Local direction and magnitude of energy flow, where measured components permit
Reference receiver waveformPulse-to-pulse repeatability and drift
Disturbance position/materialControlled change between comparison runs

Questions to Answer

Does the field map show a compact circulating structure? Does it translate without continuous support from the source? Which features persist, and which change with distance? Does a discontinuity cause deformation, delayed components, back-propagation, or loss of coherent organization? Can changes be separated from probe artifacts and ordinary antenna ringing?

Interpretation Rule

One detected pulse is not sufficient evidence of one vortex ring. The distinguishing evidence would be a repeatable spatial and temporal field pattern consistent with the proposed topology, including its behavior under controlled deformation. A null result, or a field map inconsistent with a ring, is equally useful.

Status

PLACEHOLDER — apparatus, probe design, bandwidth, calibration, and data reduction to be developed. The proposed measurement does not assume a photon identification or a universal energy-partition ratio.